At cruising speed on an open deck, music has no cabin walls to reinforce it, and it must compete with wind, engines and hull noise. Audison, the Italian company whose Thesis line represents its highest level of acoustic engineering, is taking on that problem for 2026 by extending the Thesis name into marine audio for yachts and other premium vessels. Its Thesis SAX coaxial speakers are built around a 1.5-inch dome tweeter that Audison calls the largest in the marine speaker market.
Two Sizes, Four Models

The lineup includes two four-ohm coaxials, the 7.7-inch TH 77 SAX and the 8.8-inch TH 88 SAX, each also offered in a near-flush INTEGRA version covered below. The smaller model handles 150 watts continuous and 300 watts peak, with a published response from 44 Hz. The 8.8-inch version handles 220 watts continuous and 440 watts peak, and its published response reaches 36 Hz. Audison lists both at 91 dB SPL at 2.83 volts and 1 meter.
That sensitivity figure needs context. Into four ohms, 2.83 volts equals 2 watts, so the rating works out to roughly 88 dB at 1 watt, a respectable figure for a coaxial rather than an exceptional one. Each doubling of power adds about 3 dB, which means 150 watts continuous on the smaller model yields a theoretical maximum near 110 dB at 1 meter, before thermal compression. That headroom is what keeps vocals clean over an engine at cruising rpm instead of turning harsh as an amplifier clips.
Audison states that frequency response, sensitivity and power handling are measured under IEC 60268-5 conditions in its anechoic and low-reverberation chambers, and each production unit receives end-of-line electroacoustic testing. Figures measured to a published standard compare more meaningfully across brands than unqualified claims do.
Large-Format 1.5-Inch Thesis Tweeter
The 1.5-inch Tetolon dome does more than raise output. Its larger radiating area lets the tweeter play lower, shortening the range the woofer must cover before the hand-off.
That hand-off is where coaxials often struggle. A woofer grows more directional, or beams, as rising frequency shrinks the wavelength toward the cone’s diameter. If the tweeter takes over first, off-axis sound stays consistent through the crossover region, which is also where vocals live and hearing is most sensitive. Audison says it designed the pair around this lower-than-typical crossover region, but it hasn’t published the crossover frequency or stated whether a passive crossover network is included. Both are worth confirming.
The design carries a trade-off. The larger dome that matches the woofer’s dispersion lower down narrows its own dispersion at the top of the band. Audison’s judgment appears to be that smooth coverage through the vocal range matters more on deck, where listeners spread across a wide area, than maximum spread in the top octave.
Audison says response extends to 40 kHz, meeting the Japan Audio Society’s Hi-Res Audio requirement. Nobody hears 40 kHz, least of all over an outboard. Extended bandwidth matters because it suggests the dome’s breakup modes, where it stops moving as a rigid piston, sit well above the audible band, which tends to produce a cleaner top octave.
On the Double-Wave models, the grille suspends the tweeter above the woofer. Many coaxials instead mount the tweeter on a post rising from the woofer’s pole piece through the cone, often with an extra flexible seal where the post passes through. Audison says eliminating that arrangement preserves effective cone area and efficiency. It also says the INTEGRA versions share the same drivers and acoustic performance. How the tweeter is supported behind the flush grille is worth confirming with a retailer.
High-Excursion Polypropylene Woofers
Both models use high-density polypropylene cones with UV inhibitors. Polypropylene resists moisture while offering the stiffness and low mass needed for accurate cone movement, and UV stabilization protects it from prolonged sun, such as on a flybridge in tropical latitudes.
The smaller model provides 7 millimeters of rated Xmax with a 38.6-millimeter voice coil. The 8.8-inch version raises rated Xmax to 10.75 millimeters with a 51.8-millimeter voice coil.
Cone area and excursion determine how much air a woofer can move, and therefore how loud it can play at low frequencies before running out of travel. That matters more on a boat than in a car. A vehicle cabin reinforces bass because its boundaries sit close to the listener, while an open deck offers almost none. For passengers at the stern of a center console with twin outboards running, midbass has to come from raw displacement, which gives the 8.8-inch version a meaningful advantage when output is a priority.

Both models use full neodymium motor assemblies. Audison says their high flux density delivers strong dynamics while reducing motor size and weight, and an optimized thermal circuit minimizes dynamic compression as power rises. Audison’s cutaway imagery also shows a shorting ring inside the voice coil. A shorting ring stabilizes inductance as the coil moves through its stroke, reducing distortion that varies with cone position, and lowers overall inductance to improve upper-midrange clarity.
Grilles and Lighting

Two grille designs are offered, both using identical drivers. The standard models use the three-dimensional Double-Wave grille, whose curves Audison says disperse sound into an open environment while deflecting water and reducing salt accumulation. The INTEGRA versions use a near-flush grille with a flowing parametric perforation pattern, in white or black, so the speakers visually disappear into light- or dark-colored surfaces. Integrated 12-volt RGB CCT illumination adds tunable white to standard RGB colors, letting installers match a vessel’s existing accent lighting.
Engineered for the Marine Environment
Audison specifies IP65-rated marine-grade baskets and sealed Deutsch connectors, plus water-jet testing and 1,000 hours of ASTM B117 salt-fog exposure. IP65 means dust-tight and protected against low-pressure water jets, which covers spray and wash-downs but isn’t a submersion rating. ASTM B117 is an accelerated corrosion test using continuous salt mist, and 1,000 hours is a long, demanding exposure. Deutsch connectors matter because standard spade terminals corrode in salt air. Combined with the UV-stabilized cones and water-shedding grille, these ratings point to a thorough environmental design.
Premium Sound for Life on the Water

The Thesis SAX speakers suit owners of premium vessels who want refined sound outdoors and the amplifier power to support it, roughly 150 watts continuous per channel for the smaller model and up to 220 watts for the 8.8-inch version based on Audison’s ratings. Choose the larger size for output and midbass, and the INTEGRA where the speakers should disappear.
Before buying, visit a marine-capable retailer to see the Double-Wave and INTEGRA grilles side by side, confirm cutout diameter and mounting depth for your panels, ask whether the speakers can run free-air and discuss amplifier power for an open-deck installation. Use the BestCarAudio.com Dealer Locator to find a retailer near you that can plan your Thesis marine system.
This article is written and produced by the team at www.BestCarAudio.com. Reproduction or use of any kind is prohibited without the express written permission of 1sixty8 media.
